1. Clean the position of the beard
Wash the shaver and hands, and wash the face (especially the area where the beard is).
2. Use warm water to soften the beard
Slap warm water on your face to open up your pores and soften your beard. Apply shaving foam or shaving cream to the area to be shaved, wait 2 to 3 minutes, and then start shaving.
3. Scrape from top to bottom
The steps of shaving usually start with the upper cheeks on the left and right sides, then the beard on the upper lip, and then the corners of the face. The general principle is to start with the sparsest part of the beard and put the thickest part at the end. Because the shaving cream stays longer, Hugen can be further softened.
4. Rinse with warm water
Rinse with warm water after scraping, gently pat the shaved area dry with a dry towel, do not rub it hard.
5. After shave care
The skin after shave is somewhat injured, so don't rub it. It is still necessary to stick to pat your face with cold water at the end, and then use aftershave lotion or toner, shrink lotion, aftershave honey and other aftershave care products.
Sometimes it may be too heavy, shaved too hard, causing bleeding on the face, don't panic about this. Dispose of it calmly, apply hemostatic ointment immediately, or use a small ball of clean cotton or paper towel to hold the wound firmly for 2 minutes. Then, damp a few drops of clean paper with clean water, gently stick to the wound, and then slowly peel off the cotton or paper towel.
6. Cleaning the blade
Remember to rinse the knife and put it in a ventilated place to dry. To avoid the growth of bacteria, the blades should be changed regularly. After rinsing with water, you can also soak it in 75-degree alcohol.
